Manual

AssembJyrequirestwopersons.SettheinclinetrainerinacbaredareaandremoveaHpackingmateriaUs,Do

notdisposeof thepackingmateria[suntil assemblyis completed.

Note:Theundersideoftheinclinetrainerwalkingbeltiscoatedwithhigh@erformancelubricant,Duringshipping,

asmallamountof lubricantmaybetransferredtothetopofthewalkingbeltortheshippingcarton,Thisisanor-

malconditionanddoesnotaffectinclinetrainerperformance,ifthereislubricantontopof thewalkingbelt,sim-

plywipeoffthelubricantwitha softclothandamild,non-abrasivecleaner,

Assemblyrequirestheincludeda[lenwrench _ andyourownphillipsscrewdriver_ and

c'- _. ....

wire cutters _: _._. For help identifying the assembly hardware, see the hardware drawings below.

Washer(97)-2

€©

3/4" Tek Screw (94)-10

3/4" Bolt (60)-4

1" Bolt (55)-6

3" Bolt (98)-2

1, To protect the floor during assembly, place a sheet

of cardboard under the pa[let as shown.

With the help of a second person, carefully raise the

Upright (110) to the position shown,

While the other person holds the Upright (110), firmly

tighten two 1" Bolts (55) into the lower end of the

Upright and the Upright Base (96),

insert the Power Cord (85) through the hob in the

Upright Cover (115), Press the Upright Cover onto the

Upright (110), Make sure that the Upright Cover is

secureiy held by the dips aJong the opening in the

Upright. Tighten a 3/4" Screw (66) into the lower end of

the Upright Cover,

Pallet

Cardboard