Owner's Manual

1. Make sure that the power cord is unplugged.

Remove the indicated #8 x 3/4" Screws (7) from

the back of the Console Base (98).

2. While a second person holds the Console (105),

connect the wire on the receiver to the indicated

wire extending from the Console. Next, hold the

receiver so that the antenna is oriented as

shown and is facing away from the Console.

Attach the receiver to the Console in the location

shown with the two included small screws.

3. Make sure that no wires are pinched. See

drawing 1. Reattach the Console (105) to the

Console Base (98) with the #8 x 3/4" Screws (7).

Discard the other wires included with the re-

ceiver.

If you purchase the optional chest pulse sensor (see page 26), follow the steps below to install the re-

ceiver included with the chest pulse sensor.

Wires

Antenna

Receiver

105

Small Screws