Owner's Manual

10
1. Make sure that the power cord is unplugged.
Remove the indicated #8 x 3/4" Screws (4) from
the Pulse Receiver Cover (70) on the back of the
console assembly.
2. Hold the receiver so that the antenna is ori-
ented as shown. Attach the receiver to the
Pulse Receiver Cover (70) with the two included
small screws.
3. Connect the wire on the receiver to the wire ex-
tending from the console assembly.
Make sure that no wires are pinched. Insert
the tab on the Pulse Receiver Cover (70) into the
indicated hole in the console assembly. Reattach
the Pulse Receiver Cover to the console assem-
bly with the two #8 x 3/4" Screws (4).
Discard the other wires included with the receiver.
If you purchase the optional chest pulse sensor (see page 21), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
Console
Assembly
1
70
4
3
70
Wires
Tab
4
70
Antenna
2
Small Screws
Receiver
Console
Assembly
Hole