Owner's Manual

2. Identify the Left Upright (73) and the Right

Upright (74).

ave a second person hold the Right Upright

(74) near the Right Base Cover (77). See the

nset drawing. Make sure that the long tie ex-

tends from the rectangular hole in the Right

Upright. Tie the long tie securely around the Wire

Harness (75). Next, pull the other end of the long

tie until the Wire Harness is routed through the

Right Upright.

Gently pull up on the Wire Harness (75) as you

set the Right Upright (74) on the Base (83) in-

side the Right Base Cover (77). Be careful not

to pinch the Wire Harness.

Partially attach the Right Upright (74) to the

Base (83) with two 3/8" x 3 3/4" Bolts (53) and

two 3/8" Star Washers (90). Do not fully tighten

the Bolts yet. Note: It may be necessary to tip

the tops of the Uprights forward slightly as you

thread the Bolts into the Uprights.

Attach the Left Upright (73) to the Base (83) with

two 3/8" x 3 3/4" Bolts and two 3/8" Star

Washers (not shown). Do not fully tighten the

Bolts yet.

With the help of a second person, lower the

treadmill off the cardboard stand. Save the card-

board stand for step 8.

ong

Tie

3. Identify the Right Upright Sleeve (96) and the

Left Upright Sleeve (95), which are marked with

"Left" and "Right" decals.

Slide the Right Upright Sleeve (96) onto the

Right Upright (74), and slide the Left Upright

Sleeve (95) onto the Left Upright (73).

“Right”

“Left”

Long Tie