Owner's Manual

ASSEMBLY

ssembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not

dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking

belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to

the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-

mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,

non-abrasive cleaner.

Assembly requires the included hex key and your own Phillips screwdriver , rubber

mallet , and adjustable wrench .

For help identifying the assembly hardware, see the drawings below. The number in parentheses below each

drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the

parentheses is the quantity needed for assembly. Note: Some small parts may have been preassembled. If a

part is not in the hardware kit, check to see if it has been preassembled. To avoid damaging plastic parts,

do not use power tools for assembly. Extra hardware may be included.

1. Make sure that the power cord is unplugged.

With the help of a second person, carefully tip

the treadmill onto its side as shown. Partially

fold the Frame (55) so that the treadmill is more

stable. Do not fully fold the Frame until the

treadmill is completely assembled.

Orient an Extension Leg (97) so that the Base

Pad (81) is on the side shown. Insert the

Extension Leg into the indicated bracket on the

base of the Uprights (85). If necessary, use a

rubber mallet to align the holes in the Extension

Leg with the holes in the bracket.

Attach the Extension Leg (97) with two Extension

Leg Bolts (87), two 5/16" Star Washers (110),

and two Extension Leg Nuts (91) as shown.

Firmly tighten the Extension Leg Bolts.

#8 x 3/4"

Screw (7)–6

#8 x 1"

Tek Screw (82)–8

Extension Leg Bolt (87)–4

Extension Leg

Nut (91)–4

3/8" Nut (20)–2

Base Cover Screw (63)–4

3/8" Star

Washer (67)–4

5/16" Star

Washer (110)–4

Console Bolt (72)–4

3/8" x 1 3/4" Bolts (109)–2

Bracket

110