Owner's Manual

PROBLEM: The walking belt is off-center or slips when walked on

OLUTION: a

. If the walking belt is off-center, remove the key and

UNPLUG THE POWER CORD. If the walking belt

as shifted to the left,

se the hex key to turn the

left rear roller bolt clockwise 1/2 of a turn;

if the walk-

ing belt has shifted to the right, turn the left rear

roller bolt counterclockwise 1/2 of a turn. Be careful

not to overtighten the walking belt. Plug in the power

cord, insert the key, and run the treadmill for a few

minutes. Repeat until the walking belt is centered.

b. If the walking belt slips when walked on, first remove

the key and

UNPLUG THE POWER CORD. Using

the hex key, turn both rear roller bolts clockwise, 1/4

of a turn. When the walking belt is correctly tight-

ened, you should be able to lift each edge of the

walking belt 3 to 4 in. (8 to 10 cm) off the walking

platform. Be careful to keep the walking belt cen-

tered. Then, plug in the power cord, insert the key,

and carefully walk on the treadmill for a few minutes.

Repeat until the walking belt is properly tightened.

PROBLEM: The incline of the treadmill does not change correctly

SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re-

move the key. After a few seconds, reinsert the key. The treadmill will automatically rise to the

maximum incline level and then return to the minimum level. This will recalibrate the incline system.