Owner's Manual

5. Slide a Handrail Cover (76) onto the Left

Handrail (69). See the inset drawing. Make

sure the curved side of the Handrail Cover is

acing the Upright (74).

ave a second person hold the Left Handrail

(69) near the Yoke (88). Locate the wire tie in-

side the Yoke. Wrap the end of the wire tie

around the Left Pulse Wire (70).

Pull the other end of the wire tie until the Left

Pulse Wire (70) is extending from the hole in the

Yoke (88). At the same time, slide the Left

Handrail (69) into the Yoke. Make sure not to

pinch the Left Pulse Wire. Then, slide the bot-

tom of the Left Handrail onto the bracket on the

Upright (74).

Attach the Left Handrail (69) to the Yoke (88)

with two 5/16" x 3/4" Bolts (6); do not fully

tighten the Bolts yet.

Slide the Handrail Cover (76) up the Left Handrail

(69). Attach the Left Handrail to the Upright (74)

with two 1/4" x 1" Bolts (32). Start both Screws

before tightening either of them. Then, tighten

the two 5/16" x 3/4" Bolts (6). Slide the Handrail

Cover down against the Upright.

Remove the wire tie from the Left Pulse Wire (70).

Repeat this step with the Right Handrail (75),

the other Handrail Cover (76), and the Right

Pulse Wire (71).

Wire

Tie

Wire

Tie

Bracket

6. Slide the Accessory Tray (86) onto the Yoke

(88). Partially insert the two indicated tabs and

then partially insert the other tabs. Then, fully in-

sert all of the tabs. Make sure not to break the

tabs.

Attach the Accessory Tray (86) to the Yoke (88)

with four #8 x 3/4" Screws (1). Start all four

Screws before tightening any of them. Do

not overtighten the Screws.

Tabs

Hole

Curved Side