Owner's Manual

SYMPTOM: The walking belt is off-center or slips

when walked on

a. If the walking belt is off-center, first adjust

the incline to 40 percent. Remove the key and

UNPLUG THE POWER CORD. If the walking belt

has shifted to the left, use the hex key to turn the

left idler roller screw clockwise 1/2 of a turn; if the

walking belt has shifted to the right, turn the left

idler roller screw counterclockwise 1/2 of a turn. Be

careful not to overtighten the walking belt. Then,

plug in the power cord, insert the key, and run the

incline trainer for a few minutes. Repeat until the

walking belt is centered.

b. If the walking belt slips when walked on, first

adjust the incline to 40 percent. Remove the key

and UNPLUG THE POWER CORD. Using the hex

key, turn both idler roller screws clockwise, 1/4 of a

turn. When the walking belt is correctly tightened,

you should be able to lift each edge of the walking

belt 3 to 4 in. (8 to 10 cm) off the walking platform.

Be careful to keep the walking belt centered. Then,

plug in the power cord, insert the key, and care-

fully walk on the incline trainer for a few minutes.

Repeat until the walking belt is properly tightened.

SYMPTOM: The incline trainer will not connect to

the wireless network

a. Make sure that you have followed all instructions

for connecting to your wireless network in this

manual and on the web pages (see step 1 on

page 20).

b. Make sure that the settings for your wireless net-

work are correct.

c. If you still have questions, see the front cover of

this manual.