Owner's Manual

12
77
1
1
90
3
10. See page 13 and plug in the power cord. Next,
see page 15 and turn on the power. Then, touch
the 1 Step Incline button numbered 40 on the
console. The Frame (58) will adjust to an incline
of 40 percent. Then, turn off the incline trainer
and unplug the power cord.
Identify the Left Inside Cover (3) and the Left
Outside Cover (90). Next, hold the Left Inside
Cover against the left Upright (77). Then, hold
the Left Outside Cover against the Left Inside
Cover.
Attach the Left Outside Cover (90) to the Left
Inside Cover (3) with three #8 x 3/4" Screws (1).
Start all three Screws and then tighten them.
Attach the Right Inside Cover and the Right
Outside Cover (not shown) as described
above.
58
10
12. Make sure that all parts are properly tightened before you use the incline trainer. Keep the included
hex keys in a secure place. One of the hex keys is used to adjust the walking belt (see pages 25 and 26). To
protect the floor or carpet from damage, place a mat under the incline trainer.
11. If necessary, move the incline trainer to the
desired location (see HOW TO MOVE THE
INCLINE TRAINER on page 23).
After the incline trainer is placed in the location
where it will be used, make sure that the incline
trainer rests firmly on the floor. If the incline
trainer rocks even slightly, turn the Leveling
Feet (15) as needed until the rocking motion is
eliminated.
11
1515