Manual

Our Web site at www.iFIT.com allowsyou to access
basic programs, audio programs, and video programs
directlyfrom the intemet.Additionaloptionsare soon
to be available. See www.iFIT.comfor details.
To use programs from ourWeb site, the treadmill must
be connected to your home computer. See HOW TO
CONNECT YOUR COMPUTER on page 20. In
addition, you must have an interest connection and
an internet service provider. A list of specific system
requirements is found on our Web site.
Follow the steps below to use a program from our
Web site.
_1 Insert the key fully into the console.
See GETTING STARTED on page 10.
B Select the iFIT.com mode.
When the key is in-
serted,the manual
mode will be selected.
To use a program from
our Web site, press the
iFIT.com button. The in-
dicator abovethe button willlight and the words
"IFIT MODE" will appear inthe main display.
l_lGo to your computer and start an internet
connection.
Lq Start your web browser, if necessary, and go to
our Web site at www.iFIT.com.
!_'._Follow the desired links on our Web site to se-
lect a program.
Read and follow the on-line instructions for using a
program.
r_ Follow the on-line instructions to start the
program.
When you start the program, an on-screen count-
down will begin.
B Return to the treadmill and stand on the foot
rails. Find the clip attached to the key and slide
the clip onto the waistband of your clothes.
When the on-screencountdownends, the program
will begin and thewalking pelt will begin to move.
Holdthe handrails,step ontothe walkingbelt, and
beginwalking.Dudngthe program,an electronic
"chirping" soundwillalertyouwhen thespeed
and/orinclineof the treadmillisaboutto change.
CAUTION: Always listen for the "chirp" and be
prepared for speed andlor incline changes.
If the speed or incline settings are too high or too
low, you can manually override the settings at any
time by pressing the Speed or Incline buttons on
the console. However, when the next "chirp" is
heard, the speed andlor incline will change to
the next settings of the program.
To stop the walking belt at any time, press the
Stop button on the console. The time will begin to
flash in the main display. To restart the program,
press the Start button or the Speed + button. After
a moment, the walking belt will begin to move at 1
mph. When the next "chirp" is heard, the speed
and incline will change to the next settings of
the program.
When the program is completed, thewalking belt
will stopand the time will begin to flashin the time
display.Note: To use another program,pressthe
Stop buttonand go tostep 5.
Note: If the speed or incline of the treadmill
does not change when a "chirp" is heard, make
sure that the iFIT.com indicator is lit and that
the Time display is not flashing. In addition,
make sure that the audio cable is properly con-
nected, that it is fully plugged in, and that it is
not wrapped around a power cord.
[]When the program has ended, remove the key.
See step7 on page 14.
23