Owner's Manual

26
HOW TO USE THE MAINTENANCE MODE
The console features a maintenance mode that allows
you to update the console rmware, calibrate the
incline and speed of the treadmill, view technical infor-
mation, and perform a network test.
1. Select the settings main menu.
See step 1 on page 25.
2. Select the maintenance mode.
In the settings
main menu,
touch the
Maintenance
button to enter
the mainte-
nance mode.
The maintenance mode main screen will show
information about the model and version of the
treadmill.
3. Update the console rmware.
For the best results, regularly check for rm-
ware updates.
Touch the Firmware Update button to check for
rmware updates using your wireless network. The
update will begin automatically.
To avoid damaging the treadmill, do not turn off
the power or remove the key while the rmware
is being updated.
Note: If you cannot update the console rmware
over your wireless network, you can update the
rmware using a USB drive. Go to www.iFit.com
and download the latest rmware update onto your
USB drive. Safely remove the USB drive from your
computer and plug it into the USB port on the side
of the console. If the console is in the iFit Live app,
the update should begin automatically.
The screen will show the progress of the update.
When the update is complete, the treadmill will turn
off and then turn back on. If it does not, press the
power switch into the off position. Wait for several
seconds, and then press the power switch into the
reset position. Note: It may take a few minutes for
the console to be ready for use.
4. Calibrate the incline system of the treadmill.
Touch the Calibrate Incline button. Then, touch
the Begin button to calibrate the incline system.
The treadmill will automatically rise to the maxi-
mum incline level, lower to the minimum incline
level, and then return to the starting position. This
will calibrate the incline system. Press the Cancel
button to return to the maintenance mode. When
the incline system is calibrated, touch the Finish
button.
IMPORTANT: Keep pets, feet, and other objects
away from the treadmill while the incline sys-
tem is calibrating. In an emergency, pull the key
from the console to stop the incline calibration.
5. Calibrate the speed of the treadmill.
Calibrate the speed of the treadmill only if
instructed to do so by an authorized service
representative.
Note: The Calibrate Speed button may not be
enabled on your treadmill.
6. View machine information.
Touch the Machine Info button to view information
about your treadmill. After you view the information,
touch the back button on the screen.
7. Perform a network test.
Touch the Network Test button to check the
connection status of the treadmill. The wireless
interface status shows whether the wireless feature
on the treadmill is turned on or turned off. The
network access status shows whether the treadmill
can connect to your wireless network. The DNS
service status shows whether the treadmill can
communicate with the DNS server. The iFit.com
status shows whether the treadmill can communi-
cate with iFit.com. After you view the information,
touch the Finish button.
8. Exit the maintenance mode.
To exit the maintenance mode, press the back but-
ton on the console.