Owner's Manual

13. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plas-

tic on the treadmill decals, remove the plastic. To protect the oor or carpet, place a mat under the treadmill.

Note: Extra hardware may be included. Keep the included hex key in a secure place; the hex key is used to

adjust the walking belt (see pages 29 and 30).

12. Remove the packaging material from the bottom

of the Frame (56).

See the inset drawing. Make sure that the 1/2"

Rear Leveling Foot Nuts (111) are threaded all

the way onto the Rear Leveling Feet (60). Then,

turn the two Rear Leveling Feet all the way into

the Frame (56).

Lower the Frame (56) (see HOW TO LOWER

THE TREADMILL FOR USE on page 27).

If one of the Rear Leveling Feet (60) doesn’t sit

at on the oor, turn the Rear Leveling Foot until

it is resting on the oor, and then tighten the 1/2"

Rear Leveling Foot Nut (111) against the Frame

(56).

111

11. Attach the upper end of the Storage Latch (53)

to the Frame (56) with a 3/8" x 1 3/4" Bolt (6)

and a 3/8" Nut (11).