Owners manual

SYMPTOM: The displays of the console do not

function properly

a. If the console does not boot up properly, or

if the console freezes and does not respond,

reset the console to the factory default settings.

IMPORTANT: Doing this will erase all the

custom settings you have made to the console.

Resetting the console requires two people. First,

power off the treadmill. Next, locate the small reset

opening (A) near the USB port on the console.

Using a bent paper clip (B), press and hold the

reset button inside the opening, and have a second

person power on the treadmill. Continue holding

the reset button until the console turns on. When

the reset operation is complete, the console

will turn off and then turn back on. If it does not,

power the treadmill off and then on again. Once

the console turns on, check for rmware updates

(see step 3 on page 26). Note: It may take a few

minutes for the console to be ready for use.

SYMPTOM: The console does not stay in place

a. If the console does not stay in the desired position

because it is too loose, use a hex key to slightly

tighten the console in the indicated location on both

sides (only one side is shown).