Owner's Manual

8
2. Hold the Right Upright (90) against the Frame
(56). Be careful not to pinch the wires. Start a
3/8" x 4 1/4" Screw (43) with a 3/8" Star Washer
(12) into the Right Upright and into the Frame
(56); do not fully tighten the Screw yet.
Insert a 3/8" x 2 1/2" Bolt (4) with a 3/8" Star
Washer (12) into the Frame (56). Tighten a 3/8"
Nut (34) onto the end of the Bolt; do not fully
tighten the Bolt yet.
Attach the Left Upright (not shown) in the
same way. Note: There are no wires on the left
side.
56
90
43
4
2
34
12
3. Remove the tie from the Cage Nuts (7) on both
sides of the handrail assembly (only one side is
shown).
With the help of a second person, hold the hand-
rail assembly near the Right Upright (90).
Connect the Upright Wire (84) to the Handrail
Wire (86). See the inset drawing. The connec-
tors should slide together easily and snap
into place. If they do not, turn one connector
and try again. IF YOU DO NOT CONNECT THE
CONNECTORS PROPERLY, THE CONSOLE
MAY BECOME DAMAGED WHEN YOU TURN
ON THE POWER. Then, remove the wire tie
from the Upright Wire.
Handrail
Assembly
Wire
Tie
Tie
86
90
84
7
84
86
3