User Manual

13
8
106
106
106
106
106
8. Set the Push Bar Top (110) onto the Push
Bar Bottom (109). Finger tighten six #8 x 5/8"
Machine Screws as much as possible into the
Push Bar Top.
Then, use the included offset screwdriver to
finish tightening the #8 x 5/8" Machine Screws
(106). Note: The two Machine Screws on the
outer edges of the Push Bar Bottom (109) can
be tightened with your own Phillips screwdriver.
See assembly steps 6 and 7. Tighten the eight
Screws (1, 108).
110
109
9. Slide the Right Inside Upright Cover (70) against
the lower end of the right Upright (83). Then,
press the Right Outside Upright Cover (71)
against the Right Inside Upright Cover until it
snaps into place. Make sure that the wires (E)
are not pinched.
Attach the Left Inside Upright Cover (not
shown) and the Left Outside Upright Cover
(not shown) as described above. Note: There
is not a wire on the left side.
71
83
E
9
70