User Manual

SYMPTOM: The incline trainer will not connect to

the wireless network

a. Make sure that the wireless settings on the console

are correct (see page 26).

b. Make sure that the settings for your wireless net-

work are correct.

c. If you still have questions, go to support.iFit.com.

SYMPTOM: The incline of the incline trainer does

not change correctly

a. Calibrate the incline system (see step 4 on

page 25).

SYMPTOM: The console does not stay in place

a. If the console will not stay in the desired position

because it is too loose, turn a hex key in quarter

turn increments in the two indicated locations (B)

until the console is tightened.

SYMPTOM: The displays of the console do not

function properly

a. If the console does not boot up properly, or

if the console freezes and does not respond,

reset the console to the factory default settings.

IMPORTANT: Doing this will erase all the

custom settings you have made to the console.

Resetting the console requires two people. First,

press the power switch into the off position. Next,

locate the small reset opening (C) on the side of

the console. Using a bent paper clip (D), press and

hold the reset button inside the opening, and have

a second person press the power switch into the

on position. Continue holding the reset button until

the console turns on. When the reset operation is

complete, the console will turn off and then turn

back on. If it does not, use the power switch to

turn the incline trainer off and then on again. Once

the console turns on, check for ﬁ rmware updates

(see step 3 on page 25). Note: It may take a few

minutes for the console to be ready for use.