Manual

ASSEMBLY

Assembly requires two people. Place all parts of the stepper in a cleared area and remove the packing mate-

rials. Do not dispose of the packing materials until assembly is completed. In addition to the included allen

wrenches, assembly requires an adjustable wrench _ and a rubber mallet L................ •

As you assemble the stepper, use the drawings below to identify the small parts used in assembly. The number

in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 18. The

second number refers to the quantity used in assembly. Note: Some small parts may have been pre-assem-

bled for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled.

M8 Nylon MIO Nylon M8 Split MIO Split

Locknut (28)-4 Locknut (27)-4 Washer (54)-4 Washer (30)-6

MIO x 48mm Button

Screw (99)-4

i _ i

, iiJ

M10 x 75mm Button

Screw (92)-2

M8 x 35mm

Button Bolt (24)-4

M10 x 82mm Button

Bolt (26)-4

Console

Screw (57)-4

M10 x 91mm Button

Screw (63)-2

1. While another person lifts and holds the indicated end

of the Frame (1), attach the Front Stabilizer (95) to the

Frame with two MIO x 75mm Button Screws (92).

Make sure that the Front Stabilizer is turned so the

Wheels (67) are not touching the floor.