Owner's Manual

1. While another person lifts and holds the indicated end

of the Frame (1), attach the Front Stabilizer (95) to

the Frame with two M10 x 75mm Button Screws (92).

Make sure that the Front Stabilizer is turned so

the Wheels (67) are not touching the floor.

ASSEMBLY

Assembly requires two persons. Place all parts of the stepper in a cleared area and remove the packing

materials. Do not dispose of the packing materials until assembly is completed. In addition to the included hex

keys, assembly requires an adjustable wrench and a rubber mallet .

As you assemble the stepper, use the drawings below to identify small parts. The number in parentheses below

each drawing is the key number of the part, from the PART LIST near the end of this manual. The number follow-

ing the parentheses is the quantity needed for assembly. Note: Some small parts may have been preassem-

bled. If a part is not in the hardware kit, check to see if it has been preassembled.

M10 Split

Washer (30)–6

M10 Nylon

Locknut (27)–4

M8 Nylon

Locknut (28)–4

M8 x 35mm

Button Bolt (24)–4

M8 Split

Washer (54)–4

M10 x 82mm Button

Bolt (26)–4

M10 x 91mm Button

Screw (63)–2

M10 x 75mm Button

Screw (92)–2

Console

Screw (57)–4

M10 x 48mm Button

Screw (99)–4