Owner's Manual

6. While another person holds the Console (4) near the

Upright (3), connect Extension Wire Harness (77), the

Pulse Extension Wire (98), and the ground wires to

the corresponding wires on the Console. Insert any

slack wire up into the Console and down into the

Upright.

Attach the Console (4) to the Upright (3) with four

Console Screws (57). Avoid pinching the wires dur-

ing this step.

Snap the bookrack onto the Console (4) in the loca-

tion shown.

5. While another person holds the Left Handlebar (6)

near the Upright (3), Connect the Handgrip Pulse

Wire (70) to the Pulse Extension Wire (98). Insert the

excess wiring into the Left Handlebar.

Hold two Handlebar Bushings (66) around the rectan-

gular tube on the left side of the Upright (3). Slide the

Left Handlebar (6) onto the Handlebar Bushings and

the tube on the Upright;

be careful not to damage

the the Handgrip Pulse Wire (70) or the Pulse

Extension Wire (98). Attach the Left Handlebar with

two M8 x 35mm Button Bolts (24), two M8 Split

Washers (54), and two M8 Nylon Locknuts (28).

Avoid damaging the Wires as you insert the

Button Bolts. Firmly tighten the Nylon Locknuts.

Attach the Right Handlebar (5) in the same way.

Console

Wires

Ground

Wires

Bookrack

7. Make sure that all parts of the stepper are properly tightened. Note: Some hardware may be left over

after assembly is completed. To protect the floor or carpet from damage, place a mat under the stepper.

Avoid pinch-

ing the Wires

(70, 98) during

this step

Avoid pinching the

wires during this

step