Manual

Placeallpartsof theskiexerciserina clearedareaandremovethepackingmaterials;donotdisposeof the
packingmaterialsuntilassemblyiscompleted.Assemblyrequiresonlythe includedflat wrenchtool.
1.AligntheholesintheLegBracket(2)withtheholesin
theFrontFrame(1).TheendsoftheLegBracketshould
angleawayfromtheFrontFrameandtheindicatedhole
shouldbepositionedasshown.
Usingtheincludedflatwrenchtool,attachtheLeg
Bracket(2)totheFrontFrame(1)withtwo3/8"x 5/8"
HexScrews(73)andtwo3/8"Washers(72).
2. Slidea Leg(76)intothesquareopeninginoneendof
eitherLegBracket(2).Alignthesecondholefromthe
bottomof theLegwiththeholeintheLegBracket.
Insertthestraightendof a LegPin(74)completely
throughtheholesintheLeg(76)andLegBracket(2).
ThebentendoftheLegPinshouldpointtowardthefloor
asshown.Make sure that the Leg Pin goes complete-
ly through the holes. Rotate the bent end of the Leg Pin
to secure it in place.
Attach the other Leg (76) in the same manner.
3. Lift the Upper Body Arm (27) slightly so it does not catch
on the Front Frame (1) as you raise the Upright (16).
Lift the Upright (16) and lower it into the Front Frame (1).
You will hear it snap into place when it is positioned cor-
rectly. Tighten the Upright Knob (17).
27\