Operation Manual

Door reversibility

Before carrying out any operations, remove the plug

from the power socket.

To change the opening direction of the door, pro-

ceed as follows:

1. pull off the ventilation grille (D) which is clipped

into place;

2. remove the bottom hinge (E) by unscrewing its

three fixing screws;

3. remove the door, releasing it from the upper pin

(G);

4. unscrew the upper pin (G) and refit it on the

opposite side;

5. remove the two plugs of the door (where avail-

able), discovering the holes for the hinge pins,

assemble them on the opposite side;

6. using a 10 mm spanner, unscrew the hinge pin

(E) and reassemble it on the opposite side of the

hinge;

7. reassemble the lower hinge (E) on the opposite

side, using the screws previously removed. Slide

the hole cover (F) out of the ventilation grille (D)

by pushing it in the direction of the arrow and

reassemble it on the opposite side;

8. reassemble the door;

9. refit the ventilation grille (D), clipping it into

place.

10.Dismantle the handles and reassemble them on

the opposite side. Cover the holes left open with

the plugs contained in the documentation pack.

Warning:

After having reversed the opening direction of

the doors check that all the screws are properly

tightened and that the magnetic seal adheres to

the cabinet. If the ambient temperature is cold (i.e.

in Winter), the gasket may not fit perfectly to the

cabinet. In that case, wait for the natural fitting of the

gasket or accelerate this process by heating up the

part involved with a normal hairdrier.

PR220