Operation Manual

18
Altering an option or a running programme
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause
the machine by pressing button
8.
Changing a running programme is possible
only by resetting it. Turn the programme
selector dial to «O» and then to the new
programme position. Start the new programme
by pressing button
8 again.
The washing water in the tub will not empty
out.
Interrupting a programme
Press the button
8 to interrupt a programme
which is running, the corresponding light starts
blinking. Press the button again to restart the
programme.
Cancelling a programme
Turn the selector dial to «O» to cancel a
programme which is running. Now you can
select a new programme.
Opening the door after the programme has
started
First set the machine to pause by pressing the
button
8.
If the light 9 goes off, the door can be opened.
If it does not go off, this means that the
machine is already heating, that the water level
is above the bottom edge of the door. In this
cases the door cannot be opened.
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to «O». The door can
be opened after few minutes.
(Pay attention to the water level and
temperature!).
After this procedure, it will be necessary to set
the programme and the options again and then
to press the button
8.
At the end of the programme
The washer dryer stops automatically. Some
acustic signals sound and on the display will
appear a blinking «
0 ». The button 8 light and
the light 9 go off. The door can be opened.
If, at the end of a programme, there is water in
the tub (light
9 still on), to empty out the water
follow the following instructions:
To empty out the water:
1.turn the programme selector dial to «O»
2.select the Drain or Spin programme
3.reduce the spin speed, if needed, by means
of the button
2
4.depress button 8
5.at the end of the programme, the display
shows a blinking zero «0», the light 9 goes
off and it will be possible to open the door.
Turn the programme selector dial to «O»to
switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty.
If you do not intend to carry out another wash,
close the water tap.
Leave the door open to prevent the formation
of mildew and unpleasant smells.
132966720_GB.qxd 29/05/2009 11.34 Page 18