User manual Washer Dryer WD 10146 EL
CONTENTS Safety information Product description Control panel Washing programmes Automatic Drying programmes Timed Drying Programmes Helpful hints and tips Drying Hints First use Personalisation 2 4 5 7 9 10 10 11 12 12 Daily Use 13 Use - Drying 15 Use - Washing & Drying 16 Care and cleaning 16 What to do if… 19 Technical data 22 Consumption values 22 Installation 22 Electrical connection 24 Environmental concerns 24 Subject to change without notice Important! Read carefully & keep for future referenc
• All packing and transit bolts must be removed before use. Serious damage can occur to the product and to property if this is not adhered to. See relevant section in the user manual. • After having installed the appliance, check that it is not standing on the inlet and drain hose and the worktop is not pressing the electrical supply cable against the wall. • If the machine is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely under the appliance.
To activate this device, rotate the button (without pressing it) inside the door clockwise until the groove is horizontal. If necessary use a coin. To disable this device and restore the possibility of closing the door, rotate the button anti-clockwise until the groove is vertical.
Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available). The prewash and soak detergent is added at the beginning of the wash programme. The stain remover is added during the stain action phase. Compartment for powder or liquid detergent used for main wash. If using liquid detergent pour it just before starting the programme. Compartment for liquid additives (fabric softener, starch).
Table of symbols = Rinse hold , = Child Safety Lock, 1-8 Programme selector dial, spin speed button, drying level and time, and available options Programme Selector Dial It allows you to switch the appliance on/off and/or to select a programme. Centrifugeren By pressing this button you can change the spin speed of the selected programme or to select Rinse Hold option (Spoelstop). Rinse hold By selecting this function the water of the last rinse is not emptied out to prevent the fabrics from creasing.
the time remaining is updated every minute. • Selected drying time After selecting a drying programme the drying time is shown in minutes or hours and minutes. After the programme has started, the time remaining is updated every minute. • Delayed start The Selected delay set by pressing the relevant button appears on the display for a few seconds, then the duration of the selected programme is displayed again.
Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed Maximum Fabrics Load - Type of Laundry Options Katoen 40° - 30° Main wash - Rinses Maximum spin speed at 1400 rpm Max. load 6 kg - Reduced load 3 kg1) White or colour cotton (normally or slightly soiled items). CENTRIFUGEREN RINSE HOLD KORT EXTRA SPOELEN Katoen met voorwas 60° - 40° Prewash - Main wash - Rinses Maximum spin speed at 1400 rpm Max.
Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed Maximum Fabrics Load - Type of Laundry Options Jeans 40° Main wash - Rinses Maximum spin speed at 1200 rpm Max. load 3 kg With this programme it is possible to wash items like pants, shirts or jackets in denim tissue and also jersey realized with hi-tech materials. Note! The extra rinse option (Extra Spoelen) will be activated automatically.
Degree of Drying Type of Fabric Max Load Kastdroog Suitable for items to put away without ironing Synthetics and mixed fabrics (jumpers, blouses, underwear, household linen) 2 kg Cotton and linen (sheets, tablecloths, shirts, etc.
Ball point pen and glue: moisten with acetone1), lay the garment on a soft cloth and dab the stain. Lipstick: moisten with acetone as above, then treat stains with methylated spirits. Treat any residual marks with bleach. Red wine: soak in water and detergent, rinse and treat with acetic or citric acid, then rinse. Treat any residual marks with bleach.
bed covers, quilts, sleeping bags and duvets must not be machine dried. • Avoid drying dark clothes with light coloured fluffy items such as towels as these can attract the fluff. • Remove the laundry when the appliance has finished drying. • To avoid a static charge when drying is completed, use either a fabric softener when you are washing the laundry or a fabric conditioner specifically for tumble dryers.
Child safety lock This device permits you to leave the appliance unattended so you do not need to worry that children might be injured by or cause damage to the appliance. This function remains enabled also when the washing machine is not working. There are two different ways to set this option: 1. Before pressing button 7: it will be impossible to start the machine. 2. After pressing button 7: it will be impossible to change any other programme or option.
For the compatibility among the washing programmes and the options see chapter «Washing programmes». Start the programme by pressing button 7 To start the selected programme, press this button; the corresponding green pilot light stops blinking. The pilot light 9 illuminates to indicate that the appliance starts operating and the door is locked. If you have chosen a delayed start, the machine will begin the countdown.
(Pay attention to the water level and temperature!). After closing the door, it is necessary to select the programme and options again and to press button 7. At the end of the programme The machine stops automatically. The blinking appears on the display, the pilot light of button 7 and the pilot light 9 go off.
The different type of cottons (towelling, sheets, shirts, and so on) or any laundry items rolling up during the spinning phase may result in partial dryness. In the exceptional case that at the end of the cycle the laundry remains slightly wet, we suggest that you unfold the rolled up items, redistribute them evenly in the drum and select an additional drying cycle of 20-30 minutes.
Descaling The water we use normally contains lime. It is a good idea to periodically use a water softening powder in the machine. Do this separately from any laundry washing, and according to the softening powder manufacturer's instructions. This will help to prevent the formation of lime deposits. External cleaning Clean the exterior cabinet of the appliance with soap and water only, and then dry thoroughly.
2 1 When no more water comes out, unscrew the pump cover, using pliers, and remove the filter. Always keep a rag nearby to dry up any water spillages when removing the cover. Clean the filter under a tap, to remove any traces of fluff. Replace the emergency emptying cap into the pump cover and fix it firmly. Close the pump door. Remove foreign bodies and fluff from the filter seat and from the pump impeller.
• Refit the emergency emptying cap into the filter and screw the water inlet hose back. • When you intend to start the machine up again, make sure that the room temperature is above 0°C. • Unscrew the hose from the machine. Keep a rag nearby because some water may flow. • Clean the filter in the valve with a stiff brush or with the piece of cloth. 35° 45° • Screw the hose back to the machine and make sure the connection is tight. • Turn on the water tap.
Problem Possible cause/Solution The machine does not start: The door has not been closed. • Close the door firmly. The plug is not properly inserted in the power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installation. The main fuse has blown. • Replace the fuse. The selector dial is not correctly positioned and the button 7 has not been pressed. • Please turn the selector dial and press the button 7 again.
Problem Possible cause/Solution The door will not open: The programme is still running. • Wait the end of washing cycle. The door lock has not been released. • Wait until the pilot light 9 goes off. There is water in the drum. • Select drain or spin programme to empty out the water. The machine vibrates is noisy: The transit bolts and packing have not been removed. • Check the correct installation of the appliance.
TECHNICAL DATA Dimensions Width Height Depth 60 cm 85 cm 63 cm Electrical connection Voltage - Overall power - Fuse Information on the electrical connection is given on the rating plate, on the inner edge of the appliance door. Water Supply Pressure Minimum Maximum 0,05 MPa 0,8 MPa Maximum Load Cotton 6 kg Maximum Dry Load Cotton Cotton Big Capacity Synthetic 3 Kg 4 Kg 2 Kg Spin Speed Maximum 1400 rpm CONSUMPTION VALUES Programme Energy consumption (KWh) Water consumption (litres) 2.
After removing all the packaging, carefully lay machine on it's back to remove the polystyrene base from the bottom. Remove the power supply cable and the hoses from the hose holders on the rear of the appliance. the feet. The feet may be tight to adjust as they incorporate a self locking nut, but the machine MUST be level and stable. Any necessary adjustment can be made with a spanner. Accurate levelling prevents vibration, noise and displacement of the machine during operation.
The other end of the inlet hose which connects to the appliance can be turned as showed in the picture. Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap. Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks. Caution! The inlet hose must not be lengthened.
contact your local council, your household waste disposal service or the shop where you purchased the product. Packaging materials The materials marked with the symbol are recyclable. >PE<=polyethylene >PS<=polystyrene >PP<=polypropylene This means that they can be recycled by disposing of them properly in appropriate collection containers.
132940450-A-352010