Owner manual

6-8 Maintenance
6.7 Draining the Water Trap
The facility air supply may contain moisture that can damage the dispensing system. The water trap
condenses this moisture before it enters the dispenser pneumatic system. The operator or technician
should drain the water trap weekly or whenever it is full.
WARNING! Do not remove the bowl guard protecting the water trap. The bowl is made of
polycarbonate plastic, which could rupture from over-pressurization or if the bowl
has been exposed to chemicals incompatible with polycarbonate. Removing the
bowl guard can result in serious bodily harm to the user.
Tools and Materials Needed
• Container for Waste Water
• Shop Cloth
To drain the water trap:
1. If the dispensing system is ON, press the
OFF (0) button on the operator’s console.
 Pneumatic pressure will vent.
 The light beacon will display a yellow light.
2. Disconnect the facility air supply hose from the main air inlet.
3. Verify that all pneumatic pressure gauges read 0 psi.
4. Locate the water trap at the rear of the system (see Figure 6-3).
5. Hold a container under the water trap to catch the water.
WARNING! Make sure that all air pressure to the system has been removed before opening
the drain or serious injury may occur.
6. Slowly open the water drain knob by turning to the left (counterclockwise).
7. After the trap has been drained, close the water trap drain by turning the knob to the
right (clockwise). Wipe up any spilled water with a shop cloth.
8. Reconnect the facility air supply to the main air inlet.
9. To turn on the dispensing system, press the
ON (l) button on the operator’s console.