Owner manual

Specifications 7-13
Table 7-12 Conveyor Specifications
Characteristic Specification
Speed Variable, 254 mm/sec (10 in/sec) maximum
Carrier Types Auer boats, lead frames, PCBs, or custom carriers
Rails
 Standard:
Fixed front with rear rail adjustable in the Y-direction
 Length:
1100 mm (43.3 in.)
 Width:
23–460 mm (0.9–18.1 in.)
 Height:
Adjustable from 891–965 mm (35–38 in.) (floor to top
of conveyor o-ring) Conforms to SMEMA standard.
Control Fluidmove and Conveyor/Heater Controller
Board
Clearance
X-1010
 Edge:
4.75 mm (0.187 in.)
 Under:
With Board Clamp Mechanism – 2.5 mm (0.1 in.) at
4.75 mm from board edge
Otherwise – 47 mm (1.85 in.) at 6.35 mm (0.25 in.)
 Over:
With Under Board Clamp – 9.5 mm (0.37 in.)
Otherwise – 32 mm (1.26 in.) (camera clearance)
X-1020
 Edge:
3.30 mm (0.13 in.)
 Under:
With Contact Heater – Not Applicable
With Impingement Heater – Varies (depends on
application)
 Over:
12.6 mm (0.50 in.) to stop pin with board on conveyor
o-ring
Width
Adjustment
X-1010
Motorized, Variable
19 mm (0.75 in.) minimum to 459.7 mm (18.1 in.) maximum
X-1020
Motorized, Variable
 Without Heater Tooling:
19 mm (0.75 in.) minimum
459.7 mm (18.1 in.) maximum
 With Heater Tooling:
25.4 mm (1 in.) minimum
459.7 mm (18.1 in.) maximum
Flow Direction Configurable for left-to-right (standard) or right-to-left flow
Operation Modes Automatic (SMEMA), manual, and pass-through
Board
or
Carrier
Size
X-1010
Maximum:
1 station: 457 x 457 mm (18 x 18 in)
2 station: 356 x 457 mm (14 x 18 in.)
Minimum:
Without heater tooling – 25 x 19 mm (1.0 x 0.75 in.)
With heater tooling – 25 x 25 mm (1.0 x 1.0 in.)
X-1020
Maximum:
(2)
323 x 457 mm (12.7 x 18 in.)
Minimum:
25 x 25 mm (1.0 x 1.0 in.)
Carrier Weight 1.36 kg (3 lbs.) at 178 mm/sec (7 in./sec) maximum
Minimum Carrier
Thickness
Maximum: 9 mm (0.35 in.)
Minimum: 0.13 mm (.005 in.)
Notes: (1) Refer to 3.2.2 Conveyor Features for additional information.
(2) With standard 3-station setup. With fewer stations, carriers can be larger in X dimension.