Manual

Needle Sensor 11-5
Find Needle XYZ
Find Needle XYZ is performed during programming or production runs. This routine
checks the XYZ location of the needle and returns the information to the software, which
automatically makes any needed adjustments to the dispensing program. You can run this
routine at anytime, or program it anywhere in a production run.
To perform a Find Needle XYZ:
1. In the Programming Window, select .
2. Select .
3. Follow the on-screen prompts.
Consult on-line Help for assistance.
Setup Parameters
If your system has been reconfigured recently, if you have changed the type of Needle
Sensor you are using or if you are encountering problems performing Calculate Master
Offsets, you may need to run a Setup Parameters procedure to make certain that the type of
Needle Sensor you are using is properly identified.
To setup parameters:
1. From the FMW Main Window, click on .
2. Select .
3. Select .
4. Click on the arrow next to the Sensor Type dialog box to view the available
options.
5. Choose the appropriate sensor model for your system.
6. Click on .