Manual

Needle Sensor 11-7
Option 3 – To use the Needle Sensor to perform Find Next Needle from download*:
*For Century Series, A-400 Series and A-600 Series systems only.
Whenever a new needle is installed, there is a possibility that its position is not identical to
that of the previous needle. Minor changes in needle location can result in inaccurate
dispensing. After you install a new needle, perform a Find Next Needle routine to
compensate for any change in needle location.
1. Select Download Program 6 using
Select
on the Dispenser Control Panel on
400 and 600 Series systems, or using
PROGRAM
on the control panel on Century
Series systems.
2. Press
Go
on 400 and 600 Series systems, or
START
on Century Series systems.
3. Follow the instructions in the FMDOS dialog boxes that follow.
The system will perform a needle sense after you complete these instructions.
While programming, do not insert commands
into . For more information, refer to
Fluidmove 3.3 User Guide or Reference Manual.
To ensure accurate dispensing, perform a Find Next Needle routine
every time you install a new needle.