Manual
13-2 Special Options
Operation
Opto-I/O is electrically isolated from the other components of the system. This is an
important safety feature for preventing overloads.
The three 36-pin connectors are Ports A, B and C. Port A is the default port during normal
operation and does not need to be connected to any device if it is the only active port. Ports
B and C can be activated as accessories are added. The cables are attached as needed.
To reset Port assignment to Port A, or to use Ports B or C, enter an ACL command in
Fluidmove to activate that port. ACL commands can be entered in Terminal Mode or added
to the dispensing program. There are separate procedures for Fluidmove DOS (FMDOS) and
Fluidmove for Windows (FMW).
To change a port in FMDOS:
1.
Start FMDOS.
2.
Select .
3.
Press [Enter].
4.
Select from the menu bar.
5.
Press [Enter].
6.
Select .
7.
Press [Enter].
8.
Type one of the following commands into the Terminal Mode Window:
(to activate Port A)
(to activate Port B)
(to activate Port C)
9.
Press [End].