Manual

Introduction 2-9
Power Switch
The Power Switch on the front of the system is used to turn the system power ON.
Purge Station
This station consists of a small reservoir containing a disposable plastic cup. The system has
a generator that can produce a vacuum inside the reservoir. The dispensing needle is inserted
into the top of the Purge Station lid where the vacuum removes residual fluid and cleans the
needle tip. The Purge Station is an option on the C-702 and C-708 and is standard on the
C-708 AICE systems.
Safety Interlock
The Safety Interlock System works in conjunction with the front door sensors, the Light
Curtain or the Light Beacon. Using the Safety Interlock, you can place the system in
different access modes for servicing, programming, and production. Each mode allows or
limits access to the dispensing area.
Vacuum Generator for Tooling Plate
The vacuum generator creates a vacuum on the Vacuum Heated Tooling Plate and holds the
substrate in place during the dispensing process. The Vacuum Heated Tooling Plate and the
Vacuum Generator are options on the C-702 and C-708 systems and are standard on the
C-708 AICE systems.
Vacuum Heated Tooling Plate
A vacuum holds the part in place while the plate applies a uniform temperature. The plate is
adjustable from ambient to 100°C. The Vacuum Heated Tooling Plate is an option on the
C-702 and C-708 systems and is standard on C-708 AICE systems.
Valve Pressure Gauge and Regulator
This gauge indicates the air pressure being supplied to actuate the valve or fluid pump.
Systems equipped with a Dual-Action Dispensing Head will have an additional valve
pressure gauge for the second valve. The control regulator is located just underneath the
front hood of the system.
Vacuum Switch
The Vacuum Switch may be a metal switch or a plastic button. It turns the vacuum for the
Vacuum Heated Tooling Plate ON and OFF.
Vision System
Century Series systems can be configured to use the AV-700 Target Offset Camera or the
AV-2550 Pattern Recognition System. These systems allow you to visually align fiducials as
you program for dispensing. The AV-2550 can be configured for edge detection or fiducial
identification. The AV-700 Target Offset Camera is an option on the C-702 and C-708 and
is standard on the C-708 AICE systems. The AV-2550 Pattern Recognition System is an
option on all Century Series systems.