Manual

Operation 4-23
Conveyor Adjustments
The conveyor should not need adjustments during normal operation. However, when
programming or changing parts, you may need to move the part to the left or right, or
change the width of the conveyor rails. Follow the procedures below.
To move the conveyor belts left or right:
1. Press
CONVEYOR on the Control Panel (see Table 4-4).
> The conveyor LED blinks when CONVEYOR control is active.
2. Press the left or right arrow to move the belts in that direction.
To manually adjust the distance between the conveyor rails:
1. Loosen Clamp, then manually turn the hand-crank (Figure 4-9) clockwise or
counterclockwise as applicable.
> To increase the width between the rails, turn the hand-crank clockwise.
> To decrease the width between the rails, turn the hand-crank counter-clockwise.
2. Tighten clamp.
Figure 4-9 Conveyor Hand-Crank (cutaway view)
Conveyor Troubleshooting
See Conveyor Troubleshooting in Section 6.
Conveyor Maintenance
See Conveyor Maintenance in Section 7.
Conveyor
Hand-Crank
Clamp