Manual

2-6 Installation
7. To close the ECNT Edit Screen and return to the Operator Screen, click on or select
File > Exit from the menu bar.
8. To exit ECNT, click on
or select File > Exit from the Operator Screen menu bar.
9. Restart ECNT to perform the configuration procedure.
! ECNT will prompt you to select your system configuration. See Figure 2-4.
Figure 2-4 System Configuration
10. Select your system configuration and click OK.
11. You will then be prompted to answer the following questions.
a. Does this system have a low fluid sensor?
b. Does this system have fan width control?
c. Does this system have a flow meter option?
d. Does this system have a needle finder option?
e. Does this system have an ID System (barcode scanner)?
" NOTE Questions will vary depending on the items selected to be reconfigured and
answers to previous questions. ECNT menu choices may vary depending on the
answers to the questions.
12. After you have responded to the questions, ECNT will start.