User guide

3-4 Tour of Easy Coat
Table 3-1 Operator Screen Commands (continued)
Command Description
Run Product
Click to run program. Only present when ECXP is configured for a non-
conveyorized (batch) system.
Exit Click to shut down ECXP software.
Fault Monitor Displays warning or error messages with the last message received at the top.
Silence Alarm Click to silence an alarm activated by a fault.
Clear Faults
Click to clear fault(s). Only clearable faults, such as a board failing to load, can be
cleared. Faults generated by hardware failures, such as Controller Offline, cannot
be cleared with this button. If the problem that generated the fault(s) is not
corrected, faults will re-occur.
Begin Idle
Executes the Begin Idle procedure in the currently loaded product or macro
program. Typically, the Begin Idle procedure places the nozzle in a solvent bath.
End Idle
Executes the End Idle procedure in the currently loaded product or macro
program. Typically, the End Idle procedure purges the solvent from the nozzle
before resuming production.
Periodic
This button executes the periodic procedure in the currently loaded product or
macro program. Periodic behavior is defined by the instructions in the periodic
procedures. These procedures allow a sequence of operations to be performed
periodically during production.
Go To Front Moves the tool arm to the front-center of the workcell.
Z-Home Moves the tool arm to the top of the Z-axis.
Event Monitor
Reports system events as they occur.
 Normal system events: green text
 Warnings: yellow text
 Errors: red text