Manual
Tour of Easy Coat 3-13
3.6.4 Edit Screen Tabs
The Edit Screen is divided into a series of tabs. Tabs will vary depending upon your system configuration.
Basic groups include:
• Conformal Coating
• Control
• General
• Motion
• Robot
Depending on your system hardware, additional tabs include:
• Conveyor
• Inverter
• Fan Width Control
• Needle Finder
• Camera and Vision
• Flowrate
• SC-400
Each tab contains related buttons to assist you with inserting program commands into your conformal
coating program. Basic tabs are shown in Figure 3-8. Tabs may vary depending on system configuration.
Refer to Section 5 - Programming for detailed information.
Figure 3-8 Edit Screen Tabs