Manual

4-10 Configuration and Characterization
Figure 4-10 ECXP Characterization Wizard Dialog Box
3. Click Clear Positions and then click OK to confirm.
 If you have performed a characterization before, the old test area coordinates are used
unless you clear them.
4. Click
Next.
5. Click
Yes when prompted to teach the substrate height.
6. Teach the substrate height.
a. Place a characterization sheet (Figure 4-11) in the workcell.
b. Lower the tool tip to the substrate and click
Teach Z.
c. Click
OK.
7. Enter the dispense height.
 The following variables should be considered:
- Height of tallest component to be coated
- Width of coating stripe
- Coating material flow rate and viscosity
- Coating stripe overlap
8. Enter the desired rotate position and click
Next (for applicators equipped with rotate and
cross-cut nozzles).
9. Enter the desired dispense speed and click
Next.
 NOTE Refer to the characterization sheet (Figure 4-11) for Steps 10 to 12.