Manual

System Configuration and Setup 4-49
Command Description
Heater 1
Heater 1 is the left-most heater station. Each heater station must be
configured individually and must be active to be configured. Click on the
arrow next to the Heater 1 textbox to select the heater from the list.
Heater 2
Heater 2 is the right-most heater station. Each heater station must be
configured individually and must be active to be configured. Click on the
arrow next to the Heater 2 textbox to select the heater from the list.
Reinitialize Re-establishes communication with the system heaters.
Autopurge
during wait
Activating this feature purges the valve while the dispensing system is
waiting for the temperature of the workpiece to reach the Set Point.
Purging is performed according to the settings in Fluid Manager.
Enable Skip
During Wait
If the Heaters have not reached the Set Point temperature by the time a
board is ready for dispensing, FmNT issues a warning stating that the Set
Point has not been reached. Activating this feature allows Production
Level operators to skip the wait and continue dispensing before the
heaters reach Set Point.
Purge Before
Resuming
Activating this feature purges the valve before resuming dispensing once
the temperature has reached the Set Point, regardless of the settings in
Fluid Manager.
Turn heater
channels off when
FmNT terminates
Activating this feature ensures that the Heaters turn OFF when you exit
FmNT.
Enable Pre-Heat
Timer
Activating this feature and entering the required pre-heat time in the text
box will stop production and cause an error message to display if the
workpiece is prematurely conveyed out of the pre-heat station.
Figure 4-25 Heater Setup