Manual

Programming Basics and Setup 5-19
Figure 5-10 Workpiece Alignment Options
2. Indicate the number of fiducials to be used in your program. See “Fiducials” in this section
for detailed information.
!If “No Fiducials” is selected, you have the option of confirming the workpiece origin when
opening an existing program. To activate this feature, make sure there is a checkmark in
the textbox next to “Confirm Origin location when opening an existing program that
contains no Workpiece Fiducials.”
All dispensing locations on the workpiece are defined in reference to the
workpiece origin.
The workpiece origin is defined as the point where the position counters are reset to
(x0, y0) or (0, 0).
3. Click
OK.
" NOTE Teaching the location of fiducials and origins is performed in Teach Windows
accessed from the Programming Window.