Manual

5-32 Programming Basics and Setup
6. Click on Next.
!You are asked to select a method for teaching the second fiducial.
7. Select
Model Finder.
8. Click on
Next.
9. Use the Position Controls to move the Dispensing Head to the dot in the upper right-hand
corner (URHC) of the Tutorial Board.
10. Center the crosshairs on the dot and click on
Teach.
11. Click on
Next.
!The Teach Window closes and a message box opens, indicating that the Dispensing Head
is about to move to the workpiece origin.
12. Click on
OK.
!The Dispensing Head moves to the location you defined earlier as the workpiece origin.
" NOTE If your dispensing system DOES NOT include a Height Sensor, then continue
with the next step. If your dispensing system DOES include a Height Sensor, go
to Step 17.
13. If your dispensing system does not include a Height Sensor, you are asked to teach the
substrate height.
14. Use the Position Controls to move the Dispensing Head to a location on the board that
represents the dispensing height.
!Do not teach the height of a chip or part. FmNT is requesting the height of the substrate,
not the height of a chip or part.
15. Activate the Z-Axis Controls and slowly lower the Dispensing Head until the needle tip
touches the substrate surface.
!Be careful not to crash the needle tip onto the substrate.
16. Click on
Teach.
17. Click on
Done.
!The Teach Window closes.