Manual

6-16 Beginning Programming
4. Use the Position Controls to move the crosshairs to the outer end of the rectangular spiral on
the Tutorial Board. This will be Corner 1.
5. Click on
Teach.
6. Use the Position Controls to move the crosshairs to the diagonally opposite corner of the
rectangular spiral on the Tutorial Board. This will be Corner 2.
7. Click on
Teach.
8. Click on
Done.
!The next line of your program should appear similar to the one below:
RECT SPIRAL: 0, 1, 0.200, (4.665, 3.856), (5.413, 3.353)
To program a weight control line:
" NOTE A Flow Rate Calibration must be performed before Weight Control lines are
programmed. See “Flow Rate Calibration” later in this section.
1. Click on
Dispensing Elements on the Program Commands toolbar.
!A Teach Window opens.
2. Click on
Weight Control Lines on the Dispensing Elements toolbar.
!Notice that the Teach Window has additional text boxes below the video display for weight
control lines. See Figure 6-8.
Figure 6-8 Programming Weight Control Lines