Manual

Beginning Programming 6-39
Deleting Program Commands
To delete program commands:
1. Perform the steps outlined in “Opening a Program and Pattern” above.
2. Move the cursor to the line directly below the line you wish to delete.
3. Hold down the left mouse button and move upward to select the line you wish to delete.
4. When the line is highlighted, release the mouse button.
5. Press
Delete on the keyboard to delete the line.
!The selected line will be deleted and the remaining program lines will be renumbered.
Editing Program Commands
To edit program commands:
1. Perform the steps outlined in “Opening a Program and Pattern” above.
2. Place the cursor on the line you wish to edit and double click.
!A Teach window opens.
3. Make desired changes and click
Done.
Editing Dot and Line Location
To edit dot location:
1. In the Main Window, click on
Teach a Program.
2. Open
Program1.
3. Make sure the Workpiece pattern is selected.
!Refer to “Opening a Program and Pattern” above.
4. Select
Edit>Edit Pattern from the menu bar.
5. Place the cursor on
1 DOT in the program and double-click.
!A Teach Window opens.
6. Use the Position Controls to move the camera crosshairs to upper right dot in the dots pattern
on the tutorial board.
7. Click on
Teach.
8. Click on
Done.
!The XY coordinates of your dot will change.