Manual

7-10 Advanced Programming
" NOTE You are now ready to place the pattern. The WCLine1 pattern will be called
from the Workpiece pattern.
31. In the Programming Window, select
Workpiece from the Pattern Name text box.
! A message box opens indicating that the Dispensing Head is “About to move to
Reference Origin of Workpiece.”
32. Click
OK.
33. Click the
Dispensing Elements button on the Program Commands toolbar.
34. Click the
Pattern button on the Dispensing Elements toolbar.
35. Select
Place Pattern.
36. In the Available Patterns text box in the lower portion of the Teach window, select
WCLine1.
37. Use the Position Controls to center the camera crosshairs on the dot nearest the ULHC of the
first square in the top row on Side 2 of the Tutorial Board, the same dot used for teaching the
Origin of this pattern.
38. Click on
Teach.
! Use the Position Controls to center the camera crosshairs on the dot nearest the ULHC of
the second square in the top row on Side 2 of the Tutorial Board.
39. Click on
Teach.
40. Repeat Steps 36 -39 until you have placed the pattern on all of the squares in the top row.
41. Click on
Done.
42. Select
File>Save or click on the Save icon to save the program.
43. Enter
WCLine for the filename.
! The Workpiece Pattern should appear similar to the one shown in Figure 7-8.
" NOTE In Figure 7-8, (X
1
Y
1
) are the coordinates of the pattern starting point. Your
program will have numerical values.