Manual

Tour of Fluidmove 3-17
Program Commands Toolbar
The Program Commands Toolbar is located along the right side of the Programming Window and
contains frequently used program commands. The commands associated with each icon on the toolbar
are identified in Figure 3-12. As you move the cursor over a button, notice that a “tip” appears below the
button, explaining its function. When you move it away, the tip disappears.
If a button is grayed-out, the command is not available at this point in the programming session. The
Conveyor Button is only available for systems equipped with Dual Conveyors. See Appendix A for a
detailed description of the Program Toolbar commands.
Figure 3-12 Program Commands Toolbar
Insert a Program
Commen
t
Inserts a Send
Command into
your program
Create a Pattern
Inserts Process
Commands into
your program
Inserts Procedures
into your program
Inserts Motion
Commands into
your program
Inserts timer-related
functions into your
program
Select Conveyo
r
(Dual Conveyor Systems)
Disable/Enable
Instruction
Step and Repeat
Dispensing
Elements