Instruction Manual

Backup and Restoration 7-5
8. In the [MC] menu we can transfer from the memory cassette to the PLC (>MC -> PLC) or
from the PLC to the memory cassette (>PLC->MC). See additional notes below for Autboot
PRG/RUN details shown after selecting MC->PLC. For the MH-900, Autboot RUN is
recommended. Arrow up/down, then press OK to select your desired function.
9. Press the down button to select >OK, then press OK.
 Warning! This will overwrite the data in the destination device.
10. The transfer will begin and display current progress.
11. When the loading is finished, Complete will be displayed.
 NOTES (1) The Compare menu option can be used to verify the content of the memory
cassette and the PLC before a transfer is initiated.
(2) AUTBOOT PRG: The PLC will enter program mode after loading the program from
the memory cassette immediately after power (PLC dip switch settings are
configured for Auto Transfer: ON).
(3) AUTBOOT RUN: The PLC will enter run mode after loading program from the
memory cassette immediately after power (PLC dip switch settings are configured
for Auto Transfer: ON).
(4) The CP1W-DAM01 is not compatible with CP1E hardware.
(5) The CP1W-DAM01 is only mountable in option Port 1.
[MC] PRG
>MC->PLC
PLC->MC
Compare
*
MC->PLC
Cancel
>OK
(All area)
MC->PLC
Load
99%
MC->PLC
Complete