Instruction Manual

3-2 Installation and Setup
3.4 Installing the Light Beacon
 NOTE The Light Beacon is an option.
Tools and Materials Needed:
 Light Beacon
 3 mm hex key (M4)
To install the Light Beacon:
1. Remove the beacon cover cap on the top cover.
2. While holding the pole upright, slide the cable through the slotted opening on the bracket.
3. Position the pole in the pole bracket.
4. Using 3 mm hex key (M4), tighten the M4 button head cap screw for a secure installation.
5. Plug the keyed light beacon male cable connector into the matching female connector
located in the area underneath on the inside wall.
Figure 3-1 Installing the Light Beacon