Instruction Manual

Installation and Setup 3-5
3.7 Connecting to the Facility Air Supply
To connect the system to the facility air supply:
CAUTION! Make sure that facility air pressure meets the requirements specified in
Section 2 - Safety. Higher pressures may damage the equipment.
1. Locate the facility quick-disconnect air hose.
2. Make sure the dispensing system Main Air Regulator(s) is closed. Verify facility air pressure
is at 0 psi.
3. Connect the facility air hose(s) to the quick-disconnect(s) on the Main Air Regulator(s).
4. If not already connected, also connect the air hose(s) to the facility air supply.
 Use pliers to tighten the connections.
5. Slowly open the facility air valve and listen for leaks.
 If there is an air leak, identify the source, shut off facility air, and fix the leak before
proceeding.
6. Slowly open the Main Air Regulator(s) and listen for leaks.
 If there is an air leak, identify the source, shut off facility air, and fix the leak before
proceeding.
Item Description
1 Main Air Gauge
2 Main Air Regulator
Figure 3-4 Main Air Regulator and Gauge
1
2