Instruction Manual

Installation and Setup 3-9
3.9 Configuration Menu
Prior to using your MH-900, it is necessary to perform a system configuration. Loadermove Touch
software is required for this procedure. The Loadermove Touch Configuration Menu consists of the
following items:
Table 3-1 Configuration Menu
Name Description
System Setup
Used to set the system date and time, screen contrast/brightness, and system
passwords. See 3.9.5 System Setup.
Hardware Setup
Used to adjust magazine slots, conveyor rails, sensors, pusher and/or gripper.
See 3.9.1 Hardware Setup.
Motion System Setup
Used to set the shuttle and elevator speed during run mode, the elevator and
shuttle travel limit and travel distance. See 3.9.2 Motion System Setup.
Conveyor Setup
Used to configure carrier sensor timeout and trigger off delay, pinch roller time
delay and conveyor speed. See 3.9.3 Conveyor Setup.
Preferences
Preferences lets you set beacon and jog-mode preferences. See 3.9.6
Preferences.
Jog Setup
Used to set fast and slow jog speeds for the elevator and shuttle. You can also
set elevator and shuttle travel distances through this menu. See 3.9.4 Jog Setup.
In order to configure the system, it is necessary to power on the MH-900.
To power on the system:
1. Press the green ON button on the MH-900 Control Panel (Figure 1-8).
 The Power-up Screen (Figure 3-13) opens.
Figure 3-13 MH-900 Power-up Screen
2. If prompted, clear the conveyor and press OK.