Instruction Manual

3-14 Installation and Setup
Item Description
1 MH Square Tool
2 Magazine in Slot 1
3 Reference Guide
4 Magazine Guides
5 Spring Clamps
Figure 3-22 Magazine Slot Setup
4) Place a magazine guide with spring clamp beside the magazine.
5) Slide the MH Square Tool (or other 3.1 mm-thick spacer) between the magazine
and the magazine guide.
6) Secure the magazine guide to the platform by tightening the three (3) screws.
7) Adjust the spring clamp position to cover the magazine length evenly.
d. Repeat Step 1c for the remaining magazine slots.
2. Adjust Rails to Width of Carrier.
a. From the Magazine and Part Setup window (Figure 3-19), press
to access the jog
screen.
b. Press the shuttle arrow keys to move the shuttle to the first magazine slot.
c. Press the elevator arrow keys to move the elevator until the conveyor is at the same
level as the carrier.
d. Use the 3 mm hex key to loosen the two bolts that secure the moveable MH-900
conveyor rail. See Figure 3-23.
e. Adjust the moveable front conveyor rail until you can place a carrier on the MH-900
conveyor belts.
4
1
2
3
5