Instruction Manual

Installation and Setup 3-19
Gripper/Pusher Alignment (2 of 6)
Figure 3-30 Gripper Alignment #2
1. Place an empty magazine onto the elevator.
2. Insert one part into the magazine bottom position.
3. Jog the elevator/shuttle to align the part with the conveyor belts.
 If the part is not level with the conveyor, press
to go to the Jog Screen to adjust the
elevator and shuttle.
Gripper/Pusher Alignment (3 of 6)
Figure 3-31 Gripper Alignment #3
1. Pull the part onto the conveyor to align the edge with gripper/pusher finger.
 Correct alignment is when the part is vertically centered to the gripper/pusher finger.
2. Align the center of the gripper/pusher fingers vertically to the part.