Instruction Manual

4-24 Operation
4.10.1 Running a Single Board
To run one board:
1. Select Run One Board from the Production Window (Figure 4-23).
 After system initialization is complete, the Run One Part Window (Figure 4-30) opens.
Figure 4-30 Run One Part
2. Verify that the correct recipe is selected. By default, the last selected recipe will be used.
 The current recipe name will be displayed at the top right of the Run Window.
WARNING! An incorrect recipe may damage the carriers and/or equipment.
3. If the wrong recipe is selected, press to go back to the Production Window and load
the correct recipe. See 4.9 Loading a Recipe.
4. Select the SMEMA and load options. See Table 4-3.
5. Press
to start the run. Press to pause, and to stop the run.
6. Press
to return to the Production Window.
Table 4-3 Run One Part Options
Name Description
Bypass SMEMA
YES - SMEMA signal will be bypassed.
NO - SMEMA signal will activate.
Load Carrier to
Shuttle Only
YES - Part will stop at shuttle module, sequence ends.
NO - Part travel follow single cycle sequence.