Owner's manual

5-12 SECS Scenarios
5.4.7 Go Local, Host-Initiated
Table 5-32 SECS Messages Go Local, Host-Initiated
Step SECS Message Description
1 ControlState is Remote.
2 H -> E S2F41 [W]
Remote Command (GO LOCAL). The Host commands the
Equipment to go into Local control state.
3 H <- E S2F42
If the W-bit in S2F41 is 1, the Equipment acknowledges the
command. HCACK is zero.
4 H <- E S6F11 W
The Equipment signals CEID GemControlState LOCAL. Event
Reports as appropriate.
5 H -> E S6F12 The Host acknowledges the report.
5.4.8 Operator Command, Successful
Table 5-33 SECS Messages Operator Command, Successful
Step SECS Message Description
1
ControlState is Local. The Operator issues a front-panel INITIATE
PROCESS command. The Equipment performs the command.
2 H <- E S6F11 W
The Equipment signals CEID LotStart. Event Reports as
appropriate.
3 H -> E S6F12 The Host acknowledges the report.