User Manual

5-22 Operation

5.16 Focusing the Camera

1. Position the camera over an easily recognized feature on the substrate.

2. Loosen the thumb screws on the focal ring (Figure 5-15).

3. Twist the focal ring until a sharp image is obtained.

4. Tighten the thumb screw.

5. Loosen the thumb screws on the F-stop ring (Figure 5-15).

6. Twist the F-stop ring until the desired lighting is obtained. Twist the ring one click brighter

so that when the door closes, the lighting is correct.

7. Tighten the thumb screws.

8. The camera is now ready for use.

Item Description

1 Upper Side Screw

2 Lower Side Screw

3 F-Stop Ring

4 Focal Ring

5 Light Ring (Fiducial Find Camera Only)

Figure 5-15 Focusing the Camera

 NOTE Refer to the ECXP User Guide for instructions on using the camera to teach coating

locations when creating a program.